Hyundai Santa Fe (DM): Front Door Trim. Components and Components Location - Front Door - Body (Interior and Exterior)Hyundai Santa Fe (DM): Front Door Trim. Components and Components Location

Hyundai Santa Fe DM 2013-2018 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Trim. Components and Components Location

Component Location

1. Front door trim


Repair procedures
Adjustment Glass Adjustment • Check the glass run channel for damage or deterioration, and replace them if necessary. 1. Remove the front door trim. 2. Remove the front door window glass mounting hole ...

Front Door Trim. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

See also:

Propeller Shaft. Repair procedures
Removal 1. After making a match mark on the flange yoke and transaxle companion, remove the propeller shaft mounting bolts (A). Tightening torque: 49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft) 2. Remove ...

Cylinder Block
Drive Plate. Repair procedures Removal and Installation    • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising ...

Closing the hood
1. Before closing the hood, check the following: All filler caps in engine compartment must be correctly installed. Gloves, rags or any other combustible material must be removed from the engine compartment. ...