Hyundai Santa Fe (DM): Ignition Switch Assembly - Body Electrical SystemHyundai Santa Fe (DM): Ignition Switch Assembly

Start/Stop Button. Repair procedures
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the driver crash pad lower panel. 3. Disconnect the start/stop button connector (B) after removing the center fascia garnish (A). 4. Remove ...

Repair procedures
Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. 2. Check for continuity between the terminals. 3. If continuity is not specified, ...

See also:

Front Strut Assembly. Repair procedures
Removal 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the front ...

All Wheel Drive (AWD) LOCK Indicator Light
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When you select AWD Lock ...

AUX(Auxiliary) Jack. Schematic Diagrams
Circuit Diagram ...