Hyundai Santa Fe: Input Speed Sensor. Troubleshooting
Signal Waveform
Input Speed Sensor. Schematic Diagrams
Circuit Diagram ...
Input Speed Sensor. Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. 2. Disconnect ...
See also:
26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Immobilizer Control Unit. Repair
procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. 3. Remove the knee airbag module. 4. Disconnect the connector of the immobilizer unit and then remove ...
Repair procedures
On-vehicle Inpection • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide) • Check that the battery cables ...
