Hyundai Santa Fe: Opening the fuel filler lid - Fuel filler lid - Features of your vehicleHyundai Santa Fe: Opening the fuel filler lid

The fuel filler lid must be opened from inside the vehicle by pulling the fuel

The fuel filler lid must be opened from inside the vehicle by pulling the fuel filler lid opener lever located on the driver’s door.

✽ NOTICE

If the fuel filler lid will not open because ice has formed around it, tap lightly or push on the lid to break the ice and release the lid. Do not pry on the lid. If necessary, spray around the lid with an approved de-icer fluid (do not use radiator anti-freeze) or move the vehicle to a warm place and allow the ice to melt.

1. Stop the engine.

1. Stop the engine.
2. Pull the fuel filler lid opener lever, then the fuel filler lid will pop up.
3. Pull the fuel filler lid (1) out to fully open.
4. To remove the cap, turn the fuel tank cap (2) counterclockwise.
5. Refuel as needed.

Closing the fuel filler lid
1. To install the cap, turn it clockwise until it “clicks” one time. This indicates that the cap is securely tightened. 2. Close the fuel filler lid and push it in lightly making sure that it is securely ...

See also:

Master Cylinder. Repair procedures
Removal 1. Turm ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly. 3. Disconnect the brake fluid level switch connector (B), and remove the reservoir ...

Electric power steering (EPS)
The power steering uses a motor to assist you in steering the vehicle. If the engine is off or if the power steering system becomes inoperative, the vehicle may still be steered, but it will require increased ...

TJ Joint. Repair procedures
Removal • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease. • The boot band should be replaced with a new one. 1. Remove the Front Driveshaft. 2. ...