Hyundai Santa Fe (DM): Pressure Sensor. Description and Operation - Coupling Assembly - 4 Wheel Drive (4WD) SystemHyundai Santa Fe (DM): Pressure Sensor. Description and Operation

Description

The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an oil pressure. And then it presses a multiple disk clutch and transfers the generated torque into rear wheels. Its torque value varies according to a pressure status.


Oil hydraulic Motor(Actuator). Repair procedures
Inspection If you have trouble code related to the oil hydraulic motor (actuator), check oil hydraulic motor (actuator) according to the inspection process. Oil Hydraulic Motor (Actuator) Inspection Procedure ...

Pressure Sensor. Schematic Diagrams
Circuit Diagram ...

See also:

Injector. Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is within the specification. ...

Illuminated engine start/stop button
Whenever the front door is opened, the engine start/stop button will illuminate for your convenience. The light will go off after about 30 seconds when the door is closed. It will also go off immediately ...

Components and Components Location
Components 1. Front pillar trim 2. Center pillar lower trim 3. Center pillar upper trim 4. Rear pillar trim 5. Cowl side trim 6. Front door scuff trim 7. Rear door scuff trim 8.Front door step trim 9. ...