Hyundai Santa Fe (TM): Special service tools
| Special Service Tools |
|
Engine |
Tools (Number and name) |
Illustration |
Use |
|
Diesel 2.2 TCI |
Oil seal installer 09473-D3600 |
|
Used for installing the transfer case oil seal (Driveshaft side) (Used with the handle) |
|
Handle 09231-H1100 |
|
Used for installing the transfer case oil seal (Used with the oil seal installer) |
|
|
Gasoline 2.5 MPI & Gasoline 3.5 MPI |
Oil seal #1 installer 0K473-P2100 |
|
Used for installing the transfer case oil seal #1 (Driveshaft side) (Used with the handle) |
|
Oil seal #2 installer 0K473-P2200 |
|
Used for installing the transfer case oil seal #2 (Driveshaft side) (Used with the handle) |
|
|
Oil seal #3 installer 0K473-P2300 |
|
Used for installing the transfer case oil seal #3 (Driveshaft side) (Used with the handle) |
|
|
Oil seal installer 0K473-P2400 |
|
Used for installing the transfer case (Transaxle side) (Used with the handle) |
|
|
Handle 09231-H1100 |
|
Used for installing the transfer case oil seal (Used with the oil seal installer) |
Specifications
Specifications Tightening Torques Items N.m Kgf.m lb-ft Transfer assembly mounting bolts 60.8 - 65.7 6.2 - 6.7 44.8 - 48.5 4WD ECM mounting nuts 9.8 - 11.8 1.0 - 1.2 7.2 - 8.7 Coupling assembly mounting ...
Transfer Assembly
Transfer Fluid. Repair procedures Inspection • Transfer oil should be inspected and refilled every 60,000 km (40,000 mile) / 4 year. • Be careful not to damage the parts located ...
See also:
Use high quality ethylene glycol coolant
Your vehicle is delivered with high quality ethylene glycol coolant in the cooling system. It is the only type of coolant that should be used because it helps prevent corrosion in the cooling system, lubricates ...
EBD(Electronic Brake-force Distribution). Description and Operation
Operation The EBD system (Electronic Brake force Distribution) as a sub-system of the ABS system is to control the maximum braking effectiveness by the rear wheels. It further utilizes the efficiency of ...
Front Fog Lamps. Repair procedures
Inspection Front Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction ...
