Hyundai Santa Fe (DM): Special Service Tools - General Information - Body (Interior and Exterior)Hyundai Santa Fe (DM): Special Service Tools

Special Service Tools

Tool (Number and name)
Illustration
Use
09861-31100
Sealany cut-out tool

Cutting windshield sealant
(use with 09861-31200)
09861-31200
Sealant cutting blade

Cutting windshield sealant
(use with 09861-31100)
09861-31000
Windshield molding remover

Windshield molding removal
09880-4F000
Hog ring clip installer

Hog ring clip installation
09816-2P110
Air power tool

Air tool for installing blade
09816-2P121
Cutter-1

Blade for removing the front and side area of Panorama sunroof (This blade has a inclination to push upward.)
09816-2P122
Cutter-2

Blade for removing the front and side area of Panorama sunroof (This blade has a inclination to push downward.)
09816-2P123
Cutter-3

Blade for removing the front and side area of Panorama sunroof (This blade has a inclination to push downward.)
09816-2P124
Cutter-4

Blade for removing the front and side area of Panorama sunroof (This blade has a inclination to push downward.)
09816-2P127
Cutter-5

Blade for removing the rear area of Panorama sunroof


Specifications
Specifications Items Specification Hood Type Rear hinged, gas lifter type Front Door Construction Front hinged, frame door construction Regulator system Wire drum type Locking system Pin-fork system Rear ...

Troubleshooting
Troubleshooting Symptom Suspect Area Remedy (Refer to page) Water leaks from panorama sunroof Deteriorated roof lid weatherstrip Replace Excessive roof lid-to-body clearance and improperly fitted weatherstrip ...

See also:

Repair procedures
Valve Clearance Inspection And Adjustment Inspect and adjust the valve clearance when the engine is cold (Engine coolant temperature : 20°C (68°F)) and cylinder head is installed on the cylinder block. ...

Description and Operation
Description Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to control the ...

ICM (Integrated Circuit Module) Relay Box. Components and Components Location
Component ...