Hyundai Santa Fe (DM): To set cruise control speed - Cruise control system - Driving your vehicleHyundai Santa Fe (DM): To set cruise control speed

1. Press the CRUISE button on the steering wheel to turn the system on. The CRUISE

1. Press the CRUISE button on the steering wheel to turn the system on. The CRUISE indicator light in the instrument cluster will illuminate.

2. Accelerate to the desired speed, which must be more than 25 mph (40 km/h).

3. Move the lever down (to SET-), and release it at the desired speed. The SET

3. Move the lever down (to SET-), and release it at the desired speed. The SET indicator light in the instrument cluster will illuminate. Release the accelerator pedal at the same time. The desired speed will automatically be maintained.

On a steep grade, the vehicle may slow down or speed up slightly while going uphill or downhill.

Cruise control switch
CRUISE : Turns cruise control system on or off. CANCEL: Cancels cruise control operation. RES+: Resumes or increases cruise control speed. SET-: Sets or decreases cruise control speed. ...

To increase cruise control set speed
Follow either of these procedures: Move the lever up (to RES+) and hold it.Your vehicle will accelerate. Release the lever at the speed you want. Move the lever up (to RES+) and release it immediately. ...

See also:

Timing Chain. Repair procedures
Removal 1. Remove the cylinder head cover. 2. Turn the crankshaft pulley and align its groove with the timing mark of the timing chain cover to set the piston of No.1 cylinder to the top dead center on ...

Knee Airbag (KAB) Module. Description and Operation
Description The Knee Airbag (KAB) is installed inside the crash pad lower panel and protects the driver in the event of a frontal crash. The SRSCM determines if and when to deploy the KAB. Never attempt ...

Rearview camera
The rearview camera will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through ...