Hyundai Santa Fe (DM): Automatic heating and air conditioning - Automatic climate control system - Features of your vehicleHyundai Santa Fe (DM): Automatic heating and air conditioning

1. Press the AUTO button.

1. Press the AUTO button.

The modes, fan speeds, air intake and air-conditioning will be controlled automatically according to the temperature setting.

2. Set the driver’s temperature control switch to set the desired temperature.

2. Set the driver’s temperature control switch to set the desired temperature.

✽ NOTICE

  • To turn the automatic operation off, select any button or knob of the following:
    - Mode selection button
    - Front windshield defrost button
    - Fan speed control knob
    The selected function will be controlled manually while other functions operate automatically.
  • For your convenience and to improve the effectiveness of the climate control, use the AUTO button and set the temperature to 73°F (23°C).

✽ NOTICE

✽ NOTICE

Never place anything over the sensor located on the instrument panel to ensure better control of the heating and cooling system.

Automatic climate control system
Type A Type B 1. A/C display 2. AUTO (automatic control) button 3. Blower OFF button 4. Air conditioning button 5. Driver's temperature control button 6. Front fan speed control knob 7. Air intake ...

Manual heating and air conditioning
The heating and cooling system can be controlled manually by pressing buttons or turning knob(s) other than the AUTO button. In this case, the system works sequentially according to the order of buttons ...

See also:

Electric power steering (EPS)
The power steering uses a motor to assist you in steering the vehicle. If the engine is off or if the power steering system becomes inoperative, the vehicle may still be steered, but it will require increased ...

Specifications
Specifications Items Bulb Type Bulb Wattage (W) Front Head lamp Low H11 55 High H7 55 Turn signal lamp PY28W 28 Position lamp LED LED Side marker W5W 5 Fog lamp H8 35 Rear Rear combination lmap Turn signal ...

Heated Oxygen Sensor (HO2S). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 4 and 5 [B1/S1]. 4. Measure resistance between the HO2S terminals 3 and 4 ...