Hyundai Santa Fe TM 2019-2023 Service Manual
Service manual for Fourth generation (TM) Hyundai Santa Fe. The 2019 Hyundai Santa Fe line-up offers a choice of three proven powertrains. There is a 2.4-liter inline four-cylinder GDI engine with 185 horsepower or a more powerful, turbocharged 2.0-liter four-cylinder engine with 235 horsepower (estimated). And the 2.2-liter CRDi turbodiesel engine is the 2019 Santa Fe's biggest surprise, with 190 horsepower at 3,800 rpm and 322 lb. ft. of torque at 1,750 - 2,500 rpm (estimated). All engines are mated to a brand-new eight-speed automatic transmission.
https://fliphtml5.com/homepage/ygdpq/mostbet/- General Information
- General Tightening Torque Table
- Important Safety Notice
- Identification Numbers
- Warning and Caution Labels
- Lift and Support Points
- Towing
- Basic Service Symbols
- General Service Information
- Engine Mechanical System
- Specifications
- Special service tools
- Repair procedures
- Troubleshooting
- Engine And Transaxle Assembly
- Drive Belt System
- Timing System
- Cylinder Head Assembly
- Cylinder Block
- Cooling System
- Lubrication System
- Intake And Exhaust System
- Engine Electrical System
- Emission Control System
- Description and operation
- Components and components location
- Troubleshooting
- Specifications
- Schematic diagrams
- Crankcase Emission Control System
- Evaporative Emission Control System
- Exhaust Emission Control System
- Engine Control/Fuel System
- Automatic Transaxle System (SBC)
See also:
26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Map lamp
Type A Type B Press the lens (1) to turn the map lamp on or off ON (2): The map lamp and room lamp stays on at all times. OFF (3): The lamps are off even if a door is opened. ROOM (4): The map lamp and ...
Front Strut Assembly. Repair procedures
Removal 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the front ...
