Hyundai Santa Fe (DM): Height Adjust. Components and Components Location
Component Location
|
1. Height adjust |
|
Front Seat Belt Pretensioner. Repair procedures
Replacement • When installing the belt, make sure not to damage the pretensioner. 1. Remove the center pillar upper trim. 2. After loosening the mounting bolt, then remove the front seat belt upper anchor ...
Height Adjust. Repair procedures
Replacement 1. Remove the front seat belt upper anchor. 2. After loosening the mounting bolts, then remove the height adjust (A). Tightening torque : 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft) ...
See also:
Certification label
The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross Vehicle ...
Engine Control Module (ECM). Schematic Diagrams
ECM Terminal And Input/Output signal ECM Terminal Function Connector [C100-A] Pin No. Description Connected to 1 Ignition Coil (Cylinder #2) control output [NON-smart key type] Ignition Coil (Cylinder ...
Rear Wiper Motor. Repair procedures
Inspection Rear Wiper Motor 1. Remove the connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively. 3. Check that the motor operates ...
