Hyundai Santa Fe (DM): Transaxle Oil Temperature Sensor. Description and Operation - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe (DM): Transaxle Oil Temperature Sensor. Description and Operation

Description

Transaxle Oil Temperature Sensor(OTS) monitors the automatic transaxle fluid's temperature and conveys the readings to TCM. It is an Negativen Thermal Coefficient(NTC) sensor whose resistance has an inversely proportional relationship with the temperature level. Data produced by this sensor is used to identify damper clutch activation and deactivation zones within the low temperature and high temperature range and to compensate hydraulic pressure levels during gear changes.


Transaxle Control Module (TCM). Repair procedures
Removal When replacing the TCM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used TCM] 1. Perform "TCM Neutral mode" procedure with ...

Transaxle Oil Temperature Sensor. Specifications
Specifications ▷ Type: Negative Thermal Coefficient Type(NTC) Temp.(°C)°F Resistance (kΩ) (-40)-40 48.1 (-20)-4.0 15.6 (0)32.0 5.88 (20)68.0 2.51 (40)104.0 1.11 (60)140.0 0.61 (80)176.0 0.32 ...

See also:

Lumbar support (for driver’s seat)
1. Press the front portion of the switch to increase support or the rear portion of the switch to decrease support. 2. Release the switch once it reaches the desired position. ...

Line Pressure Control Solenoid Valve. Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...

Illuminated ignition switch
Whenever a front door is opened, the ignition switch will be illuminated for your convenience, provided the ignition switch is not in the ON position. The light will go off immediately when the ignition ...