Hyundai Santa Fe: Front Door Belt Inside Weatherstrip. Repair procedures
Replacement
| 1. |
Remove the front door trim.
|
| 2. |
Remove the front door belt inside weatherstrip (A).
|
| 3. |
Install in the reverse order of removal.
|
Front Door Latch. Repair procedures
Replacement 1. Remove the front door module. 2. Remove the front door outside handle base (A) by pushing in the lock pins located in the back. 3. Open the front door outside handle cable cap (A). 4. Remove ...
Front Door Side Weatherstrip. Repair procedures
Replacement 1. Loosen the front door checker (B) mounting bolt. Tightening torque : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m,14.5 ~ 21.7 lb-ft) 2. Detach the clips, then remove the front door side weatherstrip ...
See also:
Headlamp (HID type), position (LED), turn signal, and front fog lamp bulb replacement
If the lamp bulb does not operate, have the vehicle checked by an authorized HYUNDAI dealer. WARNING - HID Headlamp low beam Do not attempt to replace or inspect the low beam (XENON bulb) due to electric ...
Power Door Lock Actuators. Repair
procedures
Inspection Front Door Lock Module Inspection 1. Remove the front door trim. 2. Remove the front door module. 3. Disconnect the connectors from the actuator. 4. Check actuator operation by connecting power ...
Instrument Cluster. Repair
procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel (A). 3. Remove the cluster (A) from the housing after removing 2 screws. 4. Disconnect the cluster connecter ...
