Hyundai Santa Fe: Fuse/Relay panel description
Inside the fuse/relay box covers, you can find the fuse/relay label describing fuse/relay name and capacity.
✽ NOTICE
Not all fuse panel descriptions in this manual may be applicable to your vehicle. It is accurate at the time of printing. When you inspect the fuse box on your vehicle, refer to the fuse box label.
Multi fuse
If the multi fuse is blown, it must be removed as follows: 1. Disconnect the negative battery cable. 2. Remove the bolts shown in the picture above. 3. Replace the fuse with a new one of the same rating. ...
See also:
Power Window Switch. Repair procedures
Diagnosis With GDS 1. The BCM can be diagnosed by using the GDS. The BCM communicates with the GDS which then displays inputs and outputs along with codes. It will be able to diagnose defects of power ...
Camshaft Position Sensor (CMPS). Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal • DON’T remove the camshaft position sensor while the engine is running or ...
Engine number
The engine number is stamped on the engine block as shown in the drawing. ...
