Hyundai Santa Fe (TM): Repair procedures - Steering SystemHyundai Santa Fe (TM): Repair procedures

Service Adjustment Procedure
Steering Wheel Play Inspection
1.
Turn the steering wheel so that the front wheels can face straight ahead.
2.
Mark the center of the steering wheel.

3.
Measure the distance that the steering wheel can be turned with out moving the front wheels.
Standard value : 0 - 30mm (1.1811in.) or less

4.
If the play exceeds standard value, inspect the steering column, shaft, and linkages.
Checking Stationary Steering Effort
1.
Position the vehicle on a level surface and place the steering wheel in the straight ahead position.
2.
Attach a spring scale to the steering wheel. With the idle RPM, pull the scale and read it as soon as the tires begin to turn.
Standard value : 3.0kgf

3.
If the measured value exceeds standard value, inspect the steering gear box.
Troubleshooting
Troubleshooting Symptom Probable cause Remedy Play in steering Loose yoke plug Retighten Loose steering gear mounting bolts Retighten Loose or worn tie rod end Retighten or replace as necessary Steering ...

Steering wheel
Components and components location Components 1. Lower cover 2. Switch bezel 3. Remote control switch 4. Paddle shift 5. Damper 6. Steering Wheel 7. Wiring 8. Drive airbag module (DAB) Repair procedures ...

See also:

Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
Specifications Direct control VFS[T/CON] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81~500.14 (0.1~5.1,1.42~72.54) Current value(mA) 50~850 Internal resistance(Ω) ...

Power Seat Motor. Repair procedures
Inspection Power Seat Motor 1. Disconnect the connectors for each motor. A : Slide motor B : Front height motor C : Rear height motor D : Lumbar support motor (Horizontal) E : Lumbar support motor (Vertical) ...

Windows
(1) Driver’s door power window switch (2) Front passenger’s door power window switch* (3) Rear door (left) power window switch* (4) Rear door (right) power window switch* (5) Window opening and closing ...