Hyundai Santa Fe (DM): Suspension System
Inhibitor Switch. Description and Operation Transaxle Control Module (TCM). Repair procedures Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the front ...
Rear Differential Carrier. Repair proceduresSee also:
Description Inhibitor Switch monitors the lever's position(P, R, N, D) and is used to control gear setting signals. ...
Removal When replacing the TCM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used TCM] 1. Perform "TCM Neutral mode" procedure with ...
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
