Hyundai Santa Fe (DM): To turn cruise control off, do one of the following - Cruise control system - Driving your vehicleHyundai Santa Fe (DM): To turn cruise control off, do one of the following

Hyundai Santa Fe DM 2013-2018 Owner's Manual / Driving your vehicle / Cruise control system / To turn cruise control off, do one of the following

  • Press the CRUISE button (the CRUISE indicator light in the instrument cluster will go off).
  • Turn the ignition off.

Both of these actions cancel cruise control operation. If you want to resume cruise control operation, repeat the steps provided in “To set cruise control speed” on the previous page.

To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the CRUISE button was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when you move the lever up (to RES+). ...

Active ECO system
...

See also:

Output Speed Sensor. Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. 2. Disconnect ...

Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with a PCM(ECM) ...

Canister Close Valve (CCV). Schematic Diagrams
Circuit Diagram ...