Hyundai Santa Fe (TM): Mirror - Body (Interior and Exterior)Hyundai Santa Fe (TM): Mirror

Outside Rear View Mirror. Components and components location

Component Location

1. Outside Rear View Mirror


Outside Rear View Mirror. Repair procedures

Replacement
  
•
Put on gloves to prevent hand injuries.
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Take care not to scratch the body surface.
1.
Remove the front door trim.
(Refer to Front door - "Front Door Trim")
2.
Using a screwdriver or remover, remove the outside rear view mirror inner cover (A).
3.
Press the lock pin, separate the outside rear view mirror connector (A).
4.
Loosen the mounting nuts and clip, remove the outside rear view mirror (A).
Tightening torque :
6.9 - 10.8 N.m (0.7 - 1.1kgf.m , 5.1 - 8.0 lb-ft)

5.
To install, reverse removal procedure.
  
•
Make sure the connector is connected properly.

Inside Rear View Mirror. Components and components location

Component Location

1. Inside Rear View Mirror


Inside Rear View Mirror. Repair procedures

Replacement
[ECM Mirror]
  
•
Put on gloves to prevent hand injuries.
1.
Remove the ECM mirror cover (A).
2.
Remove the rain sensor cover (A).
3.
Disconnect the ECM mirror connector (A).
4.
Loosen the mounted screws and push the ECM mirror base upward to remove the ECM mirror assembly (A).
5.
To install, reverse removal procedure.
  
•
Make sure the connector is connected properly.
•
Be careful not to damage the windshield glass.
[General Mirror]
  
•
Put on gloves to prevent hand injuries.
1.
Loosen the mounting screw and remove the inside rear view mirror assembly (A).
2.
To install, reverse the removal procedure.
Panorama Sunroof
Components and components location Component 1. Mechanism rail assembly 2. Center cover assembly 3. Roller blind motor 4. Glass motor 5. Panorama sunroof panel 6. Side molding 7. Decoration inner cover ...

Cowl Top Cover
Components and components location Component Location 1. Cowl Top Cover Repair procedures Replacement 1. Remove the cap and the nuts, and then remove the wiper arm (A). Tightening torque : 22.6 - 26.5 ...

See also:

Starting System
Description and operation Description The starting system includes the battery, starter, solenoid switch, ignition switch, ignition lock switch, connection wires and the battery cable. When the ignition ...

If you have a flat tire (with spare tire)
WARNING Changing a tire can be dangerous. Follow the instructions in this section when changing a tire to reduce the risk of serious injury or death. CAUTION Be careful as you use the jack handle to stay ...

Quarter Garnish. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...