Hyundai Santa Fe (TM): Trip computer (Type A)
The trip computer is a microcomputercontrolled driver information system that displays information related to driving.
Information
Some driving information stored in the trip computer (for example Average Vehicle Speed) resets if the battery is disconnected.
Trip modes
.png)
.png)
To change the trip mode, toggle the "Ë„, Ë…" switch on the steering wheel
- Manual reset
To clear the average fuel economy manually, press the OK switch on the steering wheel for more than 1 second when the Average Fuel Economy is displayed. - Automatic reset
To automatically reset the average fuel economy, select between ‘After Ignition’ or ‘After Refueling’ from the Settings menu in the instrument cluster.
- After Ignition: When the engine has been OFF for 3 minutes or longer the average fuel economy will reset automatically.
- After Refueling: The average fuel economy will reset automatically after adding 6 liters (1.6 gallons) of fuel or more and after driving speed exceeds 1 mph (1 km/h).
For 12.3-inch instrument cluster, you can check the fuel economy in the center bottom of the cluster.
Drive info
.png)
Trip distance (1), average fuel economy (2), and instant fuel economy (3) are displayed.
The information is combined for each ignition cycle. However, when the engine has been OFF for 3 minutes or longer the Drive Info screen will reset.
To reset manually, press the OK switch on the steering wheel for more than 1 second when ‘Drive Info’ is displayed.
Since refuel(l)ing
.png)
Trip distance (1), average fuel economy (2), and instant fuel economy (3) after the vehicle has been refueled are displayed.
To reset manually, press the OK switch on the steering wheel for more than 1 second when ‘Since Refueling’ is displayed.
Accumulated info
.png)
Accumulated trip distance (1), average fuel economy (2), and instant fuel economy (3) are displayed.
The information is accumulated starting from the last reset.
To reset manually, press the OK switch on the steering wheel for more than 1 second when ‘Accumulated Info’ is displayed.
Auto stop
.png)
AUTO STOP display shows the elapsed time of engine stop by Idle Stop and Go system.
Digital speedometer
.png)
Digital speedometer display shows the speed of the vehicle.
User settings mode
In this mode, you can change the settings of the instrument cluster, doors, lamps, etc. 1. Driver Assistance 2. Head-Up Display 3. Cluster 4. Lights 5. Door 6. Convenience 7. Units The information provided ...
Trip computer (Type B)
The trip computer is a microcomputercontrolled driver information system that displays information related to driving. Information Some driving information stored in the trip computer (for example Average ...
See also:
Owner maintenance precautions
Improper or incomplete service may result in problems. This section gives instructions only for the maintenance items that are easy to perform. As explained earlier in this section, several procedures ...
Engine Coolant Temperature Sensor (ECTS). Description and Operation
Description Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermistor that changes ...
Hood Latch Release Handle. Repair procedures
Replacement 1. Using a screwdriver or remover, remove the hood release handle (A). • Use a 6mm hex bit to press the center until the handle easily pulls off the post. 2. Install in the reverse order ...
